Featured Articles

IDC says PC market is rebounding

IDC says PC market is rebounding

Research firm IDC has published its latest report into the state of the PC market and while there are some signs…

More...
TSMC steps up development of 10nm process

TSMC steps up development of 10nm process

TSMC, the world’s biggest chip foundry for hire, has reportedly stepped up development of its 10nm manufacturing process.

More...
Broadwell 14nm desktop comes late in Q2 2015

Broadwell 14nm desktop comes late in Q2 2015

A while ago we mentioned that Broadwell won’t show up in the desktop space this year and we got it right.…

More...
AMD A8-7600 Kaveri APU reviewed

AMD A8-7600 Kaveri APU reviewed

Today we'll take a closer look at AMD's A8-7600 APU Kaveri APU, more specifically we'll examine the GPU performance you can…

More...
EVGA GTX 780 Classified reviewed

EVGA GTX 780 Classified reviewed

The EVGA GTX 780 Classified has been dethroned as the company’s fastest non-Titan card following the introduction of the GTX 780…

More...
Frontpage Slideshow | Copyright © 2006-2010 orks, a business unit of Nuevvo Webware Ltd.
Tuesday, 02 October 2007 17:57

Patriot 2GB Kit, DDR3 1333MHz CL7 [updated]

Written by Eliot Kucharik

Image

Review: New Kit on the block


While testing the ASUS Blitz Extreme board we had a chance to test the latest Patriot 2GB DDR3 Kit called PDC32G1333LLK, which comes with two 1GB modules.


Image


This Kit comes with the typical Patriot heatspreaders, it's rated at 1.7V, nothing special for a 1333MHz kit. The timings are quite standard, CL7-7-7-20. During our tests the heatspreaders did not heat up much.


Image


While low latencies do not imply it will run faster than the higher ones, it all depends on the mainboard you are using. The ASUS P5K3 Deluxe could run faster with CL9 and Boost 3, while the Blitz Extreme refused to run faster than Boost 0, but had no troubles using CL7.

Image

Image

The memory is rated at 1333MHz and overclocking depends on the mainboard. Our ASUS Blitz refused to run with 1500MHz, even with higher voltage, relaxed timings and deactivated boost.
[Update: October 7h, 2007]: We managed to run with 1500MHz, it was a bit tricky but it is possible :-)

We run all standards test with AUTO settings, but for our last bench we tweaked the BIOS. If you don't know what you are doing, you should avoid BIOS settings as it may ruin your Windows installation during booting. We are sure this kit could do better with other boards or more tweaking, maybe a new BIOS would help, too.

  • «
  •  Start 
  •  Prev 
  •  1 
  •  2 
  •  3 
  •  4 
  •  Next 
  •  End 
  • »
(Page 1 of 4)
Last modified on Monday, 22 October 2007 20:44
blog comments powered by Disqus

 

Facebook activity

Latest Commented Articles

Recent Comments